:	Dec 6, 2004

.

Remove both A-pillar upper trim panels.

.

Remove both B-pillar upper trim panels.

.

Remove the front overhead console.   Carefully release the 7 clips.   Disconnect the electrical connector.

.

Remove the sun visor.   Remove the cover.   Remove the 2 screws.   Release from the clip.   Disconnect the electrical connector.   Repeat the above procedure for the other side.

.

Remove the sun visor retaining clip.   Release the screw cover.   Remove the screw.   Repeat the above procedure for the other side.

.

Remove the passenger assist handle.   Release the 2 screw covers.   Remove the 2 screws.   Repeat the above procedure for the other side.

.

Lower the headliner for access.   Release the 4 clips.

.

Remove the roof opening panel motor.   Disconnect the electrical connector.   Remove the 3 Torx screws.   Remove the spacer.

.

Install the roof opening panel motor.   Install the spacer.   Tighten the Torx screws to 4 Nm (3 lb.ft).   Connect the electrical connector.

.

Position the headliner.   Secure with the clips.

.

Install the passenger assist handles.   Install the screws.   Secure the screw covers.

.

Install the sun visors.   Install the clips.   Install the screws.   Install the screw covers.   Connect the electrical connectors.

.

Install the front overhead console.   Connect the electrical connector.   Carefully secure the clips.

.

Install both B-pillar upper trim panels.

.

Install both A-pillar upper trim panels.

.

Using T4, configure a new roof opening panel motor.

.

If the battery has been disconnected, the one touch and anti-trap function will become inoperative. Close the roof opening panel and continue to hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will complete the roof opening panel calibration routine and reset these functions.